Automotive Accessories

Builder Flips a Ford 9-Inch Differential to Create a Cut-Rate Rear Portal Axle for His Jeep XJ

Astrid BerglundNovember 17, 20265 min read3 views

At a glance

  • Zeph Gage combined Humvee geared hubs, Jesse Haines adapters and an inverted differential to gain roughly six inches of clearance at about a fifth of typical portal-axle cost.
  • Zeph Gage built a rear-only portal axle for his Jeep XJ using a Ford 9-inch housing, Humvee geared hubs and an upside-down differential, cutting cost to roughly a fifth of the $20,000 typical for such setups. Keeping the front axle conventional avoided packaging and shock-travel compromises, though the build required extensive custom fabrication.
Concept illustration of a rear axle fitted with geared portal hubs and an inverted differential beneath a lifted off-road SUV in a workshop.

Portal axles are prized by hardcore off-roaders because they raise a vehicle's running gear without relying on suspension lift alone, but a set from a specialist supplier such as 74Weld typically runs about $20,000. Zeph Gage's take on the idea costs roughly a fifth of that, and it sits under the rear of his Jeep XJ only. The build combines a Ford 9-inch axle housing, geared hubs taken from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters.

What a portal axle actually does

Rather than letting shafts and driveline components hang down from the transmission and transfer case, a portal axle places a stack of gears behind each driven wheel. That arrangement lets the axle shafts sit much higher, so very little hardware protrudes below the frame line, and the raised driveline combined with tall tires yields substantial ground clearance.

Turning the differential upside down

Two-gear portals of the Humvee type reverse the direction in which the input shaft turns, which is a problem for a conventional axle. Gage's solution was to flip the differential upside down so the driveline spins the correct way, then bolt a Yukon Gear and Axle third member to it. The result is effectively a high-pinion unit assembled from low-pinion parts that have simply been inverted.

The swap is reported to do more than add about six inches of clearance. It also preserves full shock travel, a difficult thing to achieve with portal axles, and reduces stress on the differential itself, which should make the assembly effectively bulletproof as a result.

Why the front axle stays conventional

Fitting a portal only at the rear is a common trick in the radio-control rock crawler scene. Keeping the solid axle up front means Gage did not have to solve the packaging constraints that appear when portal axles are fitted to a vehicle that never left the factory with them. He also avoided restricting shock travel to make room, and the ride height stays far short of absurd, leaving what amounts to a best-of-both-worlds arrangement.

Fabrication, not a kit

The setup is not an off-the-shelf product. Gage made his own brackets and custom-tapped plates, and paired a two-piece brake rotor with a Ford Fusion caliper — chosen partly because it carries an integrated electric parking-brake solenoid and partly, again, for clearance.

The finished XJ can drive over a five-gallon bucket and still have several inches of clearance in hand, so the rear end is less likely to hang up on obstacles the front axle can simply steer around. Gage details the build, including how he matched gearing front and rear, in a video from Outdoor Auto.

Reported by Astrid Berglund, Vehicle Cargo and Roof System Analyst.